aligning walls

[SupraXT]

any idea for me that will help me align my walls, like castle walls?

[IcIshoot]

zoom in real close. Then move one wall so that it end is exactly over the end of the next wall.

I first put the walls in as close together as I can then start at one end, select the second wall in the line zoom in and then align the second wall to the first. Then I make sure the second wall isn't selected and select the third wall aligning it with the second wall. Do that to all the walls.

If I'm going to use a lot of walls, I'll get the walls how I like then select 5 of them and copy and past, rotating them if I have too.

Hope this helps

[SupraXT]

how do i zoom?

[Xx_jet_xX]

Try puting something small in the corner you want to line up, like a fence post. Select that after you select what you want to move. You can zoom in to see that and your corners to get it exact. Shift + right mouse and move your mouse to the left or right to zoom in and out.

[Steve]

zoom = page up / page down

[Kaleb]

use the pg.up/down after u click the spot u want to zoomin onwith mouse 3, or usethe numpad

[Doper-ISK-]

before u zoom hold control and right click then u center the screen .set the snap in the left up to 1 meter selct all your walls rightclick >snap to grid.now they exactly line up.
just move em with the arrow keys to the right spot

[Kaleb]

i dont see snap to grid? could that be because of my version of med? im running the med that works for xp, not the unlocked version

[Doper-ISK-]

object has to be selected when u rite click.in the 2 d editor that is.

[peregrine falcon]

read the manual that is on the cd u may have to load acrobat reader fromthe dflw cd to read it

CENTER: CTRL+right click centers map by click

ZOOM: page up/down, numpad + & - , numpad 3 & 9, shift right click and move side to side

SNAP: is a checkbox upper right of med if it is selected objects will be placed at closest grid intersection

GRID: a map grid that can be adjusted by + & - buttons by gridbox(above SNAP)

ADJUST objects: use arrow keys to fine adjust objects 1/256th M, use CTRL and arrow keys to move 1 M

most objects will snap to a 1-2M grid however some u have to adjust manually (concrete,wood,etc walls)

[blade~SD~]

how do i zoom in on object to aline them like ladders and fences?

[blade~SD~]

how do i make tunnals? i would like to make some for my new map

[Doper-ISK-]

lol i didnt notice before this is for landwarrior

[peregrine falcon]

most of the 2d med controls are the same for LW and BHD

to zoom check my post above

!!!TUNNELS!!!!
tunnels snap to a 2M grid

the Z value is 8M this means the first tunnel section is 8M less than the entrance 2nd level of tunnels is 8M less than first

tunnels have to have a blink group #(lower left of item attributes window) otherwise there will be a black area at end of each tunnel section

tunnel entrances must be selected as blink group parent(checkbox by blink group # box)