Mapping Tunnels

[Sybell]

I am developing a map and I am on flat ground. I insert the tunnel with it's entrance with a Z value of 0 onto the map. I run the game and the tunnel and entrance are 6 feet off the ground! I change the Z value to -5 and it brings them to ground level, but then when I get into the entrance and start down the ladder, I get blocked.

Any ideas?

[dave61]

Use the wireframe to set the tunnels, the enterance should be just above the ground level.

( HINT : set your grid to 1m then "snap" the tunnels pieces together using the grids, also check the absolute height box to keep the object from moving up or down while you move the object !)