my day been (totally bad day)

[Hellfighter]

will i started out 10am to day to start to cut up some trees trimming

had two elect-chainsaws get stuck into oak tree (trim only was going to do? did not workout that way) branches, had to dig up my gas power chain saw to cut them lose.

then as the day go on around 2pm (14;hrs)
my aunts house next door to us, a dang tree started to fall onto the power lines almost on them, i had to drop everything and started to cut that tree totally down.

step:
1.) tie the tree so it don't fall anymore onto the power lines.
2.) tie it to the rider lawn mower. to pull it away from the power line. talk about digging up rope/chains to use.
3.) cut a "V" cut into the trunk of the tree to fall away from the lines.
4.) after cut back side to release the tree to fall forward into the V-Cut.
5.) get on the rider mower (not a small rider mower ether big type) started to pull the tree almost work, dang tree swing side ways then back to the power lines. i gas the rider mower! it came down ok. only it taken out her cable line for the cable Tv service.

did save the power lines not a total lost.

can't win them all. (she was a bit mad about the cable service out)

man i am sore all over.

tomorrow i add in some snapshots of it. its too dark-out side.

so much for taken a easy day working on some tree over my place.

have 5 chainsaws
*1-elect 14" stander type Remington (1992)
*1-elect 10" pole chainsaw Remington (new 2007)
1-elect 6" elect butterfly chain saw B&D (new 2007)

**1-gas/oil 20" chainsaw poulan (new 2007)
1-gas/oil 24" chainsaw mc culloch (old 1995)

*stuck up in the tree like 12ft up
was trying to cut a main Branch away 8"
**cut lose