need info on tools to make tablesaw

[Hellfighter]

there is item 2 & 3 i really have no clue on their size they should be made to. if any one can help it would help me a lot.

[Scott]

What model table saw is it?

[Hellfighter]

Modle: 174315
Make: Tradesman
Blade size: 10"
Bench table saw

[the þrox™]

Those objects are used to push wood into the saw without cutting your fingers off, i wouldnt worry about those, if you want one you buy them at home depot.

[Hellfighter]

gee i gone there and look for them none at all. i even ask the worker's there seem they don't have a clue what i am talking about? i even show them image right out of the book.

the long handle (item 1 in image above) is the only thing they did have USD-14.00. i can make it in 2min its no big deal. but i be cutting plywood 1/4" to 1/2" thick full sheets 4'x8' with the table-saw. it no trouble cutting 2"x4"x8' but thin sheet it be better have the right items for it. those other tool can be made i think i have to try on my own without the size to go by ref; item: 2 & 3.

[Scott]

it's just a push block and a push stick (Sorry, didn't know you were asking what they were). PLus a feather board etc, You can get some with sticky (but not sticky) on the bottom to push thinner wood through, and the puch stick for thinner peices of wood like thin trim.

http://www.amazon.com/exec/obidos/tg...203481-4489563

http://www.amazon.com/exec/obidos/tg...&s=hi&n=228013

http://www.amazon.com/exec/obidos/tg...203481-4489563

Hehe thats where I work

[Hellfighter]

Originally posted by Panther
What model table saw is it?

Item number: BTS10BW #53433


ok thanks

think this be the best bit i'll order it then use it as a template to make others made from wood.



still have to look into item #3