uh oh??
 

Hum not to sure which esction so i chose this one

I got a Micro AtX mobo (mATX) and i got a Med Tower ATX do you think i till be able to put teh mobo in teh case

Link to Mobo- http://www.newegg.com/Product/Produc...82E16813130533

Case- http://www.imtechnology.com.au/produ...roducts_id=264

Says it does but i am not to sure. (I Currently Own that Case)

should :\ you might need to screw in the mounts onto the case so you can screw the mobo on.. that's about it ..

Most cases made for mb's bigger then Micro ATX should work with smaller MB's. I've never had a problem fitting a mirco atx motherboard in a mid atx or full atx case.

I am hoping so because i dont wanna buy a Case and still ahve that AOpen sitting around

Will try to fit it tomorrow

yeah it will be ok, it's still ATX

Expansion Slots
AGP Slots None
PCI Express x16 1 (GFX-Card slot AKA: PCIe 16x)

it don't use a normal GFX-Card for it, but its a lot better type.

http://s15.photobucket.com/albums/a3...h_debe8b12.jpg

MOB like the setup.:gj: good find

Thx

It fits had dificulty getting teh last screw to go it but it fits

i know the feeling same here when i put my all together.

i set all the screw loosely in then after i tighten them all up. work like a chrome;)

you mean Charm?

I did to but the last one wouldn't go in so i had to Use a Drill to get it to go in Lmao i got it running and planning to run #dmark shortly when i get all my Insalations complete :| over 30 gig of Software :| (not Games)(Yet)